HTC Bolt‎

Guide Downloads

< < Menu

nano SIM card

HTC Bolt uses a nano SIM card.

The nano SIM card is preinstalled on HTC Bolt. If you need to remove or replace the card, refer to the following instructions.

Use a standard nano SIM card only. Inserting a modified card that is thicker than the standard nano SIM card may cause the card to not fit properly or damage the card slot.
Image warning against using a modified SIM card.

Inserting a nano SIM card

  1. Hold the phone face up.
  2. Insert the tip of the tray eject tool (or a small bent paperclip) into the tray eject hole next to the nano SIM card slot.
  3. Push the tip all the way into the hole until the tray ejects, and then pull the tray out.
  4. Place the nano SIM card (contacts facing down) into the tray.
  5. To reinsert the nano SIM tray, center it first in the slot, and then slide it all the way in.
  6. Press on the cover that's attached to the tray. Make sure the cover doesn’t protrude from the side.

Removing a nano SIM card

Important: Make sure to switch off HTC Bolt before removing the card.
  1. Hold the phone face up.
  2. Insert the tip of the tray eject tool that came with your phone—or a small bent paperclip—into the nano SIM tray eject hole.
  3. Push the tip all the way into the hole until the card tray ejects.
  4. Pull the card tray out, and remove the nano SIM card.
  5. To reinsert the nano SIM tray, center it first in the slot, and then slide it all the way in.
  6. Press on the cover that's attached to the tray. Make sure the cover doesn’t protrude from the side.
Was this information helpful?

Can’t find what you’re looking for?